Inverter Hardware
How to Tune snshs on ZombieVerter VCU
Heatsink temperature sensor type.
Quick Reference
Param ID
45
Unit
enum
Range
0 — 7
Default
0
Available Choices
0: KTY83
(default)
1: KTY84
2: PT1000
3: NTC
4: NTC2
5: NTC3
6: NTC4
7: NTC5
📖 What Does It Do?
Heatsink temperature sensor type.
🎯 Recommended Values
Default value: 0
Valid range: 0 to 7
💡 Tuning Tips
0=KTY83/84, 1-7 other sensor types. Match your hardware.
Tune snshs and All 80+ Parameters
Answer a few questions about your specific build and get a complete, validated config file ready to load.
Generate Your Complete Config →Free account • No credit card • Takes 5 minutes
🔗 Related Parameters
Other parameters in the Inverter Hardware category that work together with snshs:
pwmfrq
enumPWM switching frequency. Higher = cleaner motor but more IGBT heating.
deadtime
digIGBT dead time between high/low-side switching. CRITICAL safety param.
ocurlim
AOvercurrent limit. If RMS current × √2 exceeds this, inverter trips.
il1gain
dig/ACurrent sensor 1 gain. MUST be calibrated for accurate current measurement.
il2gain
dig/ACurrent sensor 2 gain. Same as il1gain but for second phase.
udcgain
dig/VDC bus voltage measurement gain.
pwmpol
enumPWM polarity. Depends on gate driver design.
udcofs
digDC bus voltage measurement offset.
pinswap
enumPin swap configuration. Swaps resolver sin/cos or other signals.