How to Tune GearLvr on ZombieVerter VCU

Select your gear selector/shifter type. Tells the VCU how to interpret gear position inputs (Park, Reverse, Neutral, Drive).

Quick Reference

Param ID

108

Unit

enum

Range

0 — 4

Default

Available Choices

0: None (no shifter) (default) 1: BMW F30 shifter 2: JLR Gen1 shifter 3: JLR Gen2 shifter 4: BMW E65 shifter

🔍 See a sample config →

📖 What Does It Do?

Select your gear selector/shifter type. Tells the VCU how to interpret gear position inputs (Park, Reverse, Neutral, Drive).

🎯 Recommended Values

Default value: 0

Valid range: 0 to 4

Tune GearLvr and All 80+ Parameters

Answer a few questions about your specific build and get a complete, validated config file ready to load.

Generate Your Complete Config →

Free account • No credit card • Takes 5 minutes

🔗 Related Parameters

Other parameters in the General Setup category that work together with GearLvr:

Inverter

enum

Select the type of inverter/motor controller you're using. This is THE most important parameter — it configures CAN bus ...

Vehicle

enum

Select the vehicle platform you're converting. This configures CAN bus messages for instrument cluster, reverse lights, ...

Transmission

enum

Transmission type. Manual = you shift gears yourself. Auto = single-speed or automatic.

InverterCan

enum

Which CAN bus is the inverter connected to? ⚠️ REQUIRED — set this to the CAN bus your inverter is on. If you only have ...

VehicleCan

enum

Which CAN bus is the vehicle systems connected to? ⚠️ REQUIRED — set this to the CAN bus your car's original systems are...

ShuntCan

enum

Which CAN bus is the current shunt connected to? If you don't have a CAN-based shunt (ISA shunt, etc.), leave this at CA...

LimCan

enum

Which CAN bus is the charge limiter connected to? If you don't have a charge limiter, leave this at default. The VCU won...

ChargerCan

enum

Which CAN bus is the charger connected to? Only matters if you have a CAN-connected charger. If chargemodes is 'Off', th...

MotActive

enum

Which motors are active? For single motor builds use MG1 only.

interface

enum

Select your charging interface/protocol. Different charging standards use different protocols.

← Back to All Guides Next: Transmission →