Throttle & Regen
How to Tune ampmin on ZombieVerter VCU
Minimum amplitude/power at zero throttle. Prevents deadband.
📖 What Does It Do?
Minimum amplitude/power at zero throttle. Prevents deadband.
🎯 Recommended Values
Default value: 10
Valid range: 0 to 100
Tuning Strategy
Start with the default value and adjust in small increments. Monitor vehicle behavior after each change before making further adjustments.
💡 Tuning Tips
10% = motor always gets at least 10% amplitude at 0 throttle.
Reduce if motor creeps when it shouldn't. Increase if throttle feels dead off-idle.
Tune ampmin and All 80+ Parameters
Answer a few questions about your specific build and get a complete, validated config file ready to load.
Generate Your Complete Config →Free account • No credit card • Takes 5 minutes
🔗 Related Parameters
Other parameters in the Throttle & Regen category that work together with ampmin:
regentravel
%Throttle travel zone dedicated to regen (from 0% pedal).
brakeregen
%Regen amount when brake pedal is pressed.
regenrampstr
HzMotor frequency at which regen ramping starts.
offthrotregen
%Regen amount when throttle is fully released (off-throttle regen).
brklightout
%Regen level that triggers brake light output.
slipstart
%Slip percentage at which motor starts producing torque.
throtcur
A/%Current per percent throttle — this is your POWER control. Higher = more torque.
cruiseregen
%Regen applied during cruise control deceleration.