Throttle & Regen
How to Tune brakeregen on ZombieVerter VCU
Regen amount when brake pedal is pressed.
📖 What Does It Do?
Regen amount when brake pedal is pressed.
🎯 Recommended Values
Default value: -50
Valid range: -100 to 0
Tuning Strategy
Start with the default value and adjust in small increments. Monitor vehicle behavior after each change before making further adjustments.
💡 Tuning Tips
Tune brakeregen and All 80+ Parameters
Answer a few questions about your specific build and get a complete, validated config file ready to load.
Generate Your Complete Config →Free account • No credit card • Takes 5 minutes
🔗 Related Parameters
Other parameters in the Throttle & Regen category that work together with brakeregen:
ampmin
%Minimum amplitude/power at zero throttle. Prevents deadband.
regentravel
%Throttle travel zone dedicated to regen (from 0% pedal).
regenrampstr
HzMotor frequency at which regen ramping starts.
offthrotregen
%Regen amount when throttle is fully released (off-throttle regen).
brklightout
%Regen level that triggers brake light output.
slipstart
%Slip percentage at which motor starts producing torque.
throtcur
A/%Current per percent throttle — this is your POWER control. Higher = more torque.
cruiseregen
%Regen applied during cruise control deceleration.