How to Tune fconst on ZombieVerter VCU

Constant power frequency. Above fweak, below fconst — power stays constant.

Quick Reference

Param ID

Unit

Range

0 — 1000

Default

180

🔍 See a sample config →

📖 What Does It Do?

Constant power frequency. Above fweak, below fconst — power stays constant.

🎯 Recommended Values

Default value: 180

Valid range: 0 to 1000

Tuning Strategy

Start with the default value and adjust in small increments. Monitor vehicle behavior after each change before making further adjustments.

💡 Tuning Tips

Only used in some motor control modes. Leave at default.

Tune fconst and All 80+ Parameters

Answer a few questions about your specific build and get a complete, validated config file ready to load.

Generate Your Complete Config →

Free account • No credit card • Takes 5 minutes

🔗 Related Parameters

Other parameters in the Motor Control category that work together with fconst:

fmax

Maximum motor frequency. RPM = fmax × 60 / polepairs.

boost

dig

Voltage at 0 RPM — controls starting torque. Higher = stronger launch.

fweak

Field weakening start frequency. Above this, motor enters constant-power region.

numimp

ppr

Speed sensor pulses per revolution.

polepairs

Motor pole pairs. CRITICAL — set this correctly for your motor.

fslipmax

Maximum slip frequency (induction motors). Sets full-throttle torque.

snsm

enum

Motor temperature sensor type. Must match your motor's actual sensor.

fslipmin

Minimum slip frequency (induction motors). Sets creep torque.

encmode

enum

Encoder/position sensor type. This is your motor's 'eyes' — it tells the inverter where the rotor is.

dirchrpm

rpm

RPM below which direction change is allowed.

← Back to All Guides Next: fslipconstmax →