How to Tune throtrpmfilt on ZombieVerter VCU

RPM signal filter for throttle. Higher = smoother but slower response.

Quick Reference

Param ID

131

Unit

rpm/10ms

Range

0.1 — 200

Default

🔍 See a sample config →

📖 What Does It Do?

RPM signal filter for throttle. Higher = smoother but slower response.

🎯 Recommended Values

Default value: 15

Valid range: 0.1 to 200

Tuning Strategy

Start with the default value and adjust in small increments. Monitor vehicle behavior after each change before making further adjustments.

Tune throtrpmfilt and All 80+ Parameters

Answer a few questions about your specific build and get a complete, validated config file ready to load.

Generate Your Complete Config →

Free account • No credit card • Takes 5 minutes

🔗 Related Parameters

Other parameters in the Throttle category that work together with throtrpmfilt:

potmin

dig

Throttle pedal MINIMUM raw ADC value (pedal fully released).

potmax

dig

Throttle pedal MAXIMUM raw ADC value (pedal floored).

pot2min

dig

Second throttle channel MINIMUM (for dual-channel pedals). Leave at 4095 if unused.

pot2max

dig

Second throttle channel MAXIMUM.

potmode

enum

Throttle input mode. Single = one pot. Dual = redundant channels for safety.

dirmode

enum

Direction control mode. How the VCU determines forward/reverse.

DirChange

enum

Restrict direction changes while moving (safety).

DirChangeRpm

rpm

RPM threshold for direction change restriction.

reversemotor

enum

Reverse motor rotation. Set to 1 if motor spins wrong way.

throtramp

%/10ms

Throttle ramp rate. How fast motor responds to pedal. Lower = smoother.

← Back to All Guides