Throttle
How to Tune RegenBrakeLight on ZombieVerter VCU
Regen level that triggers brake light output.
📖 What Does It Do?
Regen level that triggers brake light output.
🎯 Recommended Values
Default value: -15
Valid range: -100 to 0
Tuning Strategy
Start with the default value and adjust in small increments. Monitor vehicle behavior after each change before making further adjustments.
💡 Tuning Tips
Set to -15% as starting point. Too high (closer to 0) = brake light flashes constantly. Too low = regen happening without brake lights.
Tune RegenBrakeLight and All 80+ Parameters
Answer a few questions about your specific build and get a complete, validated config file ready to load.
Generate Your Complete Config →Free account • No credit card • Takes 5 minutes
🔗 Related Parameters
Other parameters in the Throttle category that work together with RegenBrakeLight:
potmin
digThrottle pedal MINIMUM raw ADC value (pedal fully released).
potmax
digThrottle pedal MAXIMUM raw ADC value (pedal floored).
pot2min
digSecond throttle channel MINIMUM (for dual-channel pedals). Leave at 4095 if unused.
pot2max
digSecond throttle channel MAXIMUM.
potmode
enumThrottle input mode. Single = one pot. Dual = redundant channels for safety.
dirmode
enumDirection control mode. How the VCU determines forward/reverse.
DirChange
enumRestrict direction changes while moving (safety).
DirChangeRpm
rpmRPM threshold for direction change restriction.
reversemotor
enumReverse motor rotation. Set to 1 if motor spins wrong way.
throtramp
%/10msThrottle ramp rate. How fast motor responds to pedal. Lower = smoother.