Throttle
How to Tune regenrpm on ZombieVerter VCU
RPM where regen reaches maximum effect. Lower = regen kicks in harder at low speed.
📖 What Does It Do?
RPM where regen reaches maximum effect. Lower = regen kicks in harder at low speed.
🎯 Recommended Values
Default value: 1500
Valid range: 100 to 10000
Tuning Strategy
Start with the default value and adjust in small increments. Monitor vehicle behavior after each change before making further adjustments.
💡 Tuning Tips
Lower (500-1000): Stronger one-pedal feel at low speeds.
Higher (1500-3000): Smoother regen, more like engine braking.
If regen feels grabby at low speed, increase this value.
Tune regenrpm and All 80+ Parameters
Answer a few questions about your specific build and get a complete, validated config file ready to load.
Generate Your Complete Config →Free account • No credit card • Takes 5 minutes
🔗 Related Parameters
Other parameters in the Throttle category that work together with regenrpm:
potmin
digThrottle pedal MINIMUM raw ADC value (pedal fully released).
potmax
digThrottle pedal MAXIMUM raw ADC value (pedal floored).
pot2min
digSecond throttle channel MINIMUM (for dual-channel pedals). Leave at 4095 if unused.
pot2max
digSecond throttle channel MAXIMUM.
potmode
enumThrottle input mode. Single = one pot. Dual = redundant channels for safety.
dirmode
enumDirection control mode. How the VCU determines forward/reverse.
DirChange
enumRestrict direction changes while moving (safety).
DirChangeRpm
rpmRPM threshold for direction change restriction.
reversemotor
enumReverse motor rotation. Set to 1 if motor spins wrong way.
throtramp
%/10msThrottle ramp rate. How fast motor responds to pedal. Lower = smoother.