How to Tune idlespeed on ZombieVerter VCU

Idle speed target. -100 = disabled.

Quick Reference

Param ID

Unit

rpm

Range

-100 — 10000

Default

-100

🔍 See a sample config →

📖 What Does It Do?

Idle speed target. -100 = disabled.

🎯 Recommended Values

Default value: -100

Valid range: -100 to 10000

Tuning Strategy

Start with the default value and adjust in small increments. Monitor vehicle behavior after each change before making further adjustments.

💡 Tuning Tips

Set to 500-1000 for creep. -100 = no idle control.

Tune idlespeed and All 80+ Parameters

Answer a few questions about your specific build and get a complete, validated config file ready to load.

Generate Your Complete Config →

Free account • No credit card • Takes 5 minutes

🔗 Related Parameters

Other parameters in the Auxiliary category that work together with idlespeed:

pwmgain

Aux PWM gain/scaling.

pwmofs

dig

Aux PWM offset.

speedkp

Speed control proportional gain.

speedflt

Speed measurement filter.

pwmfunc

enum

Auxiliary PWM output function.

cruisemode

enum

Cruise control mode.

idlethrotlim

Idle throttle limit. Prevents runaway.

idlemode

enum

Idle control mode.

canspeed

enum

CAN bus speed.

tripmode

enum

Trip behavior on overcurrent/fault.

← Back to All Guides Next: speedflt →