How to Tune tripmode on ZombieVerter VCU

Trip behavior on overcurrent/fault.

Quick Reference

Param ID

Unit

enum

Range

0 — 3

Default

🔍 See a sample config →

📖 What Does It Do?

Trip behavior on overcurrent/fault.

🎯 Recommended Values

Default value: 0

Valid range: 0 to 3

💡 Tuning Tips

0=Normal, 1=DualShore, 2=SingleShore, 3=BootList

Tune tripmode and All 80+ Parameters

Answer a few questions about your specific build and get a complete, validated config file ready to load.

Generate Your Complete Config →

Free account • No credit card • Takes 5 minutes

🔗 Related Parameters

Other parameters in the Auxiliary category that work together with tripmode:

pwmgain

Aux PWM gain/scaling.

pwmofs

dig

Aux PWM offset.

speedkp

Speed control proportional gain.

idlespeed

rpm

Idle speed target. -100 = disabled.

speedflt

Speed measurement filter.

pwmfunc

enum

Auxiliary PWM output function.

cruisemode

enum

Cruise control mode.

idlethrotlim

Idle throttle limit. Prevents runaway.

idlemode

enum

Idle control mode.

canspeed

enum

CAN bus speed.

← Back to All Guides Next: outmode →